Replacement diaphragm for the pump on the Weber ICT series carburetors.
This diaphragm has a cam with, Nylon, spring-loaded tip.
The total height of the cam + tip is 12.5 mm, measured from the face of the disc.
The diameter of that disc is 22 mm.
Please note that this diaphragm is supplied as shown in the picture, with the extra eyelet and spring-loaded tip.
This eyelet serves no purpose on the ICT application and consequently can be cut off if you desire to do so but it can also remain in place.
Please compare this diaphragm visually and carefully with your old diaphragm as over the course of the years, various different versions were used which are not necessarily interchangeable.
Required quantity per carburettor: 1
This is item number 14 in the drawing.
Weber Part Number: 47407.261
Operating principles of the acceleration pump and the role of the diaphragm in this:
This diaphragm is activated by a lever that is connected to the throttle lever(s).
When releasing the throttle, a spring returns the diaphragm to its initial position and by doing so, it sucks-in fuel into the pump chamber, from the float chamber.
A one-way valve prevents this fuel from leaking back into the valve chamber.
When you then activate throttle, that same lever pushes the diaphragm inwards and the pressure that is thus created makes the fuel being squirted downstream with the main airflow through the pump jet.
This extra flow of fuel will prevent "fuel starvation" from occurring when the throttle is suddenly opened which allows large quantities of air being sucked into the engine.
When you then release the throttle again, the diaphragm is again pushed back by the spring, thus priming the pump chamber with a fresh supply of fuel and making it ready to repeat the procedure.
This is an excellent system that has been employed for decades by various makes of carburetors and applied to all kinds of applications.
So, not only Weber but also Solex, Pierburg, Zenith and Mikuni used this system with more or less identical operating principles.
However, to ascertain a flawless operation of this system, the diaphragm need to be in excellent condition.
The original diaphragms are now coming of age and are suffering from the ravages of aggressive modern fuels which causes the "rubberized textile" material to harden or even crack, causing erratic running of the engine and fuel leaks.
Replacing the diaphragm is then the only sensible option which is a rather simple operation.
A complete overview of our pump diaphragms for Weber carburettors can be found HERE.