Facet CUBE Solid State ROAD Fuel Pump only.
Using Facet's proven "CUBE Solid State" technology, the CUBE Solid State ROAD fuel pump is suitable for engines of up to circa 130 HP.
- Flow rate 30 Gallons/hour - 113.5 liters/hour
- Pressure: 3.0 - 4.5 PSI - 0.20 - 0.30 Bar
- Dry prime height 1 Ft - 0.3 Mtrs
- Pipe union thread size: 1/8" NPTF tapered thread
- 12 Volt negative earth
- Suitable for nearly all fuels, including modern ones, but NOT suited for Methanol
Please note that failure to operate the pump without a suitable filter voids the warranty!
Suitable screw-on filters can be found HERE.
Please note: this concerns ONLY the pump body... no further connectors or mounting material!
These single pumps are usually purchased to replace a broken pump.
In case you want to equip your vehicle with such an electrical pump system, we advise you to take a look at our Facet CUBE Solid State ROAD Fuel Pump Kit.
Depending on your vehicle's carburetors and the Facet CUBE pump of your choice, it might be required to use a pressure regulator.
Please check the CUBE specifications against the requirements of your vehicle to be sure.
Connection to pump body: 1/8" NPTF tapered thread
Please use our superior quality PTFE tape each time that you (re-)assemble screwed connections in the fuel tract in order to properly seal the connection.
As an alternative, you can use our Loctite 243 Thread Locker which will offer the added properties of protecting your connections from undoing themselves.
We strongly advise you to secure your fuel lines using our Stainless Steel Jubilee Clips.
When using an electrical fuel pump, we also advise you to equip your vehicle with an Inertia Fuel Cut-Off Switch as a safety precaution.
Facet Pump Number: 40105