10005.447 Late Type Throttle Spindle for Weber DCOE carburetor

10005.447
Throttle spindle for a 40 or 45 mm LATE TYPE Weber DCOE carburetor.

Please note that this throttle shaft is only suitable for late type Weber DCOE's that use a sealed bearing.
If your carburetor uses the leather & spring seal, you require a different shaft.

Also, this shaft uses the "flat head "screws and again, if your carburetor uses countersunk screws, you need a different shaft.

You can make a visual comparisson by using the images on this page.

It will fit the 40 and 45 mm versions of the Weber DCOE.

Also please note:
These shafts are supplied without the hole for the roll pin to secure the pump arm.
Throughout the years, the location of the pin varied and consequently, you will have to copy the location from your old shaft and drill the hole yourself.

This product is priced, and sold, as a single unit.
Required quantity per carburettor: 1

This is item number 85 in the drawing of the Weber DCOE carburetor.

This is Weber Part Number: 10005.447

* Made in Europe *

10005.447 Late Type Throttle Spindle for Weber DCOE carburetor

10005.447 Late Type Throttle Spindle for Weber DCOE carburetor

10005.447 Late Type Throttle Spindle for Weber DCOE carburetor